Drywall Repair in White Plains, NY

Drywall repair in White Plains runs from a doorknob hole in a hallway to a full ceiling replacement after a leak. We patch drywall and plaster, replace water-damaged sections, and hang new board taped and mudded to a paint-ready finish. Every job starts with a free, no-obligation on-site estimate and a line-item quote, so you know what you're paying for before we start.

Usually responds in about a minute

What the work covers

Most calls start with one of three things: a hole from a doorknob or a piece of furniture, a crack along a seam or where two walls meet, or a water-stained section on a ceiling or wall. Before we patch a water-stained area, we need to know the leak behind it is resolved and the material underneath is dry — patching over damp drywall or framing doesn't hold, and the stain or crack just comes back.

Once the area is dry, we cut the damaged section back, back it so the patch has something solid to bite into, board it, tape it, and run three coats of mud, sanding between coats. That gets the patch to a paint-ready surface — smooth and level with the surrounding wall, ready for primer and paint.

We also hang new drywall from scratch when a wall or ceiling needs replacing, taped and mudded to the same paint-ready finish. Repainting the repaired or new section is quoted as its own line, since matching the sheen and color across old and new surface is a separate step with its own prep.

What we see in White Plains homes

White Plains has a mix of older single-family homes and condo and co-op buildings, including high-rises near the downtown area.

How we price it

Drywall repair starts at $375 for the first wall patch, and each additional patch is $125. A patch is each separate area of damage — three holes in one wall are priced as three patches, not as one room or one visit. Ceiling patches run at twice the wall price, since ceiling work takes more rigging and more care with dust and debris overhead.

New drywall installation — hung, taped, and mudded to a paint-ready finish — is priced at $2.50 per square foot of wall surface, with ceilings at twice the wall rate. A full standard room, about 16 sheets of board, comes to $1,600.

The estimate visit is free and comes with no obligation. We look at the damage, note what's a patch and what's a full install, and leave you a line-item proposal so each piece of the job is priced separately.

What's included and what's quoted separately

We bring all materials — board, tape, mud, primer, paint, hardware — and they show up as their own lines on the quote. You choose the paint color and sheen; we handle the application.

We cover floors and furniture near the work area before cutting into drywall or plaster, and we clean up dust and debris at the end of each visit.

Skim coating, demo work, and type-X board for a garage or basement are quoted as separate lines, since they're a different scope than a standard patch. Repainting is also its own line, for the same reason — it's a distinct step with its own prep and dry time.

Timing and living through the work

A patch typically takes two to three visits, because mud needs real dry time between coats. Rushing that step is what leaves a visible seam or a crack that comes back a few months later, so we schedule around the drying window instead of compressing it into one trip.

Every quote comes with a certificate of insurance attached. If your co-op or condo board asks for proof of insurance before work starts, we send ours ahead of the visit.

Why a licensed local contractor matters

We're licensed and insured — Westchester County Home Improvement Contractor license WC-40688-H26 — and based in Mount Vernon, serving Westchester County and the Bronx, including White Plains.

New requests get a 30-minute response target, and every repair carries a one-year workmanship warranty. Unit rates for drywall and painting are published on our site, so pricing for common repairs isn't a mystery before we even show up.

Published drywall rates
First patch (walls)
$375
Each additional patch
$125
Ceiling patches
2× the wall price
New install (hang + tape + mud)
$2.50 / sq ft of wall surface
Ceilings (new install)
2× the wall rate
Full standard room (~16 sheets of board)
$1,600

Labor rates. Materials we supply are their own lines on the quote, and the exact number comes with the free on-site estimate. See all published rates.

Recent projects in White Plains

All our projects in White Plains→More about our drywall repair→

Drywall Repair in White Plains: questions we get

How much does a drywall patch cost?

The first wall patch is $375, and each additional patch is $125. Ceiling patches are priced at twice the wall rate.

Do you repair water-damaged drywall or ceilings?

Yes, once the source of the moisture is resolved and the material underneath has dried out. Patching over an active leak or damp drywall doesn't hold, so we check that before we start the repair.

Will the paint match after the patch is done?

Repainting the repaired wall is quoted as its own line, since matching color and sheen across old and new surface is a separate step with its own prep, not something rushed in with the patch itself.

Do I need to buy the drywall or paint myself?

No. We supply all materials, and they appear as their own lines on the quote. You pick the paint color and sheen.

Can you send proof of insurance to my building's board?

Yes. A certificate of insurance is attached to every quote, and if your co-op or condo board wants it ahead of the visit, we send it over.

How long does a patch take?

Most patches take two to three visits, since the mud needs time to dry between coats before sanding and finishing.